especificación	CR-C and S60H

Descripción
Comentarios de clientes(0)

Item specifics

Brand Name Kawish
External Testing Certification NONE
Origin CN(Origin)
Model Name CR-C S60H
Electronic No
Hardware Version V6.0
Item Height 22cminch
Item Length 40cminch
Power 50W
Material Type Plastics and iron
Item Type Electrical Testers & Test Leads
Special Features CABLE connect
Item Weight 8kgkg
Software Version V6.0
Voltage AC220V/110V
Item Width 40cminch
Special Features injector tester
function 1 electromagnetic injector tester
function 2 for bo-sch/for del-phi/for den-so injector tester
plug type: EU and US plug to choose

Product Description

CR-C Common Rail Injector Tester +

Common rail diesel nozzle Injector tester S60H

Note:

CR-C tester just can test electromagtic injector, can not test piezo injector.If you need test both electromagtic and piezo injector ,please click the link:

https://www.lotusrite.com/item/32833478074.html?spm=5261.ProductManageOnline.0.0.32354edf35l3Iw

How to test a common rail Injector ?

Need two conditions:

1,Electrical pulse signal (CR-C Common Rail Injector Tester)

2,High pressure fuel (S60H Common rail diesel nozzle Injector tester)

As Shown below picture, it's the basic method.

PRODUCT 1:

CR-C Common Rail Injector Tester

CR-C common rail injector tester is a easy operated tool, could do the test with the injector hand pumps. It's small size and light weight, could meet the requires from repairman on the simple device of testing.

Technical Parameters:Produce Model: CR-C Common Rail Injector TesterTesting Range: atomization, pilot, emission and full load condition.Test Injectors: for Boscch, Densso, Delphii common rail injectors.Working Voltage: AC220V/AC110Working Temperature: -30C°--70C°Size: 110*250*190mmAdjustable Width: 10 MS

PRODUCT 2:

Common rail diesel nozzle Injector testerS60H

Diesel Injector Nozzle Pop Tester fuel injector nozzle tester with 0 - 400 BAR / 0 - 6000 PSI Dual Scale Gauge BOSCH injector checker is suitable for all common rail injector and mechanical injectors, auxiliary products have compression release valve, it can check the fuel injection conditions of various types of injector quickly and easily. It also can be used with common rail injector 118 solenoid valve tester to test various types of common rail injectors. The injector checker equipped with two different types of tubing. You can freely switch suitable for detecting the injector, it is a good choice to Initial inspection injector working state.

HOW to Test

As we know drivercommon rail injector,not only need a tester but also need hight pressure fuel,

so we used a manul fuel pressure pump S60H as show in followpicture

1, the high pressure oil common rail injector directly or into the holder is connected to the common hand pressure calibrator.

2, according to the corresponding plug injector brand choice, will harness and injector connected up correctly.

3, according to the fuel injector brand, drive mode selecting corresponding, at this time can hear the injector solenoid valve suction armature "Pa, Pa" voice.

4, by constantly under pressure calibrator lever, provide the suitable injection pressure, the general pressure value takes 30-40MPA best, at this time can be observed on the fuel injector atomization performance.

5, through the external cylinder, can be detected on the injector fuel injection quantity and oil return.