[xlmodel]-[products]-[55441]

[xlmodel]-[custom]-[55440]

Features: 

Description:

l 1. Remove the screws that fix the resin bucket on the side where you want to install the drip stand

l 2. Fix the drip holder as a whole to the thread, and then tighten the thumb screw again

l 3. During the printing process, the drip tray cannot touch your bottom plate

l 4. After printing, move up the build platform

l 5. Remove the platform and hang it on the bracket

l 6. The uncured resin will drip back into your trough

l 7. You can close the lid as needed

Specification:

l Size: length about 50mm, width about 20mm, height about 55mm

l Applicable models: Phrozen Sonic Mini, Most other 5.5 / 6 LCD 3D Printers where the resin vat is secured with thumbscrews

Packing includes:

l 1 x Resin Drip Stand

Note:

l Not applicable models: all models of Anycubic (the printing platform is different)

[xlmodel]-[photo]-[0000]

[xlmodel]-[custom]-[55442]