Features:

• The sensor can be adjusted to work under both daylight and night lights,

• or it can be set to work only under night lights.

• Easy to install.

• Adjustable light working hours.

• This product is a ceiling infrared motion detector, used to control lights. 

• It utilizes the infrared energy from human as detection,

• as soon you move into the area of the sensor it will switch the lights on,

• once you move away from the area and after a pre-programmed time,

• the sensor will power off the lights. 

• You can have the sensor working in night only or day and night,

• this unit has 6m range and 360 Degree detection angle. 

• It  can be used in toilets, bathrooms zone 3 only and practically anywhere

• where you want to save energy it is widely used where people forget to turn light switches off. 

Specification:

• 100% brand new with high quality

• Rest Dips are light time delay, 5 sec, 30 sec, 1, 3, 5 or 8 minutes.

• Sensor box measurements: 5.6 cm x 3.4 cm x 2.4 cm

• (Sensor head wire is detachable from the box so it would fit through a hole when installing)

• Detection Angle: ceiling installation 360°, horizontal installation 100°

• Detection Range: 6m

• IP Rating: IP20

• Time Setting: 5Sec.30Sec.1.3.5.8Min.Off

• Power Source: 220-240V/AC

• Rated Load: 800W

• Max Power Frequency: 50/60Hz

• Ambient Light: Work Temperature: -10~+40

Installation:

• 1st dip if its ON it will only detect movement in a night light.

• If its OFF it will also work in the day time and Night time. 

• 2nd dip is a sensitivity when its ON it is set on a low sensitivity

• when its OFF  it is set on a high sensitivity (it can detect wind and other non human movement)

Package Included:

• 1 x PIR Sensor Detector

• 1 x Use manual

Note:

• The colors may be a little difference for the different monitor display. 

• Please check as much as possible to make sure the item is the one that you need.

• Please allow 0.5-1 inch difference due to manual measurement.(1inch=2.54cm)