GBP retro pixel IPS LCD kit

Please use the constant voltage 1.5 volt Lithium battery.

IPS panels are characterized as having the best color and viewing angles.

Perfectly compatible grayscale adjustment button for brightness adjustment.

Built-in 36 retro color combinations.

11% larger than the original LCD.

LCD and the ribbon of the overall power consumption between 0.3 w to 0.8 w.

Perfectly mimics the spacing between pixels in early LCDS. Almost the same picture.

LCD KIT INCLUDE:

IPS LCD × 1

GBP Ribbon × 1

Custom installation tape × 1

Glass Lens × 1

HOUSING INCLUDE:

GBP housing X1

Screw set X1

The rubber pads NOT included

NOTES

All items are carefully tested before sending.

Test the kit before installation! Need to solder the power point then test.

The LCD is very thin and light. Please check whether the ribbon is running normally after receiving the goods and install it on the handheld.

The GBP kit requires retrofitting the construction of the shell, welding a power line and the touch unit. It takes a little hands-on skill.

Since GBP USES two AAA batteries, the maximum capacity we can find is at 1100mWh.

According to our repeated tests, it ran the original cartridge at normal brightness indoors for about 3 hours.

If you use the burn card, it will greatly reduce the endurance.

It is recommended to use an electronic cleaner to handle your power switch and grayscale adjustment buttons.

This makes the LCD brightness adjustment smoother to use.

Please make sure to test before put into the shell when receiving the goods.

Please use the constant voltage 1.5 volt Lithium battery.