1. Connect the motor cable (three) and the Hall plug (five)

2. Connect the power cord, (note the positive and negative do not reverse) and the electric door line

3. Turn on the electric door switch

4. Two self-study line connect to each, if the motor reverses, disconnect the self-learning line, re-plug in, the motor turn positive. If the motor does not turn, check the line, or have other conditions.

5. Turn the motor for 1 minute and then disconnect the self-study line.

6. Connect the Twisted wire (commissioning), if the motor does not turn. Adjust the Twisted wire line to the order, until the motor can rotate normally. If the motor can be normal turn, connected to the brake line, three-speed, anti-theft, reversing, etc., so the wiring is completed

Feature:

Anti-coaster features
Overcurrent protection
Automatic identification the 36V and 48V
Automatic identification the Hall sensor
Automatic identification the Phase angle of 60 degrees and 120 degrees
Low level/E-ABS brake
High level/E-ABS brake
Applicable model: electric bicycle,electric scooter

Note: It only fit for Motor with sensors. This is a simple edition

Specifications:
Casing material: Aluminium
Rated voltage: DC 36V/48V
Rated power: 350W
Current: 16-18A
Size: 10.3x7x3.5cm/4.06x2.76x1.38inch
Quantity: 1 Pc
Note:
Please allow 1-3mm error due to manual measurement. pls make sure you do not mind before you bid
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!


Package Contents: 
1 x Brushless motor controller