The black lens is actually dark gray. Close to the original Nintendo color. Because we used to call it black. And the color is very close to black. There is color difference in taking photos. It looks like black.

The wire on the cable must be connected to the positive pole of the battery base! The wires on the cable are very thin. If it is broken, please weld a new wire by yourself. We are not responsible.

Product features:

1) IPS LCD screen. Small amount of shell cutting, simple installation.No welding is required.
2)Touch to adjust brightness and change color. Short touch is to adjust backlight brightness, long touch is to change color.Black and white, retro, green, dark yellow, bright yellow five color adjustment.
3)The usage time is OK. With the 900 Ma Xiaomi battery, the screen has the highest brightness, and the battery life is 3 to 4 hours.Different game cartridge, use time will be different.
4)The screen display scale is correct, 4 points to 1 point.
5)The size of the display screen is the same as the original one, can use the original lens.

Each set of LCD has been tested before shipment. You can test it again like this before installing.

Test before installation. It is helpful to find out the causes of problems in later installation.

Please see the installation precautions first. The installation tutorial is at the bottom.

Do not squeeze the back and border of the LCD. Squeezing can cause uneven backlight, light spots and black spots. As shown in the figure below, due to the extrusion of the LCD frame, there are bright spots on the edge.
The cable of LCD screen should be folded tightly. As shown in the figure below. So the LCD screen won't be squeezed by the cable.
If the touch cable is lost or the cable holder is damaged, it can be replaced by ordinary wire. Weld as shown in the figure below.
Do not wipe the LCD screen with a coarse paper towel. It will leave a scratch.
Do not wipe the LCD screen with a very wet paper towel. The LCD will water in. There are light spots and dark spots.
Remove the LCD protective film and install the LCD immediately. Do not touch the LCD with your hands. In this way, the LCD screen will be perfect.
Do not fold the part of the cable with electronic components, which will result in LCD display failure.

Installation tutorial

1) For non Nintendo original cases, check the window for burrs. Remove the burr.
2) Cut the housing as shown. Trim flat, avoid squeezing LCD screen.
3) First paste the double-sided adhesive for fixing the LCD screen. If lost, it can be replaced by ordinary double-sided tape.
4) Then paste the black strip tape. Used to center the LCD screen. If it is lost, please paste other stickers with thickness of 0.5mm.
5) The LCD screen can be aligned to the upper right corner.
6) Pay attention to fully insert the LCD cable and fasten the cable base.
The exposed metal wire shall not touch any metal other than the power supply, which will cause short circuit, the battery will be very hot, and the LCD screen cannot be used.
the solder joint of the wire is relatively small. If it falls off, you need to weld it yourself
The cable for touch adjustment of LCD brightness and color must touch the shell.