The black lens is actually dark gray. Close to the original Nintendo color. Because we used to call it black. And the color is very close to black. There is color difference in taking photos. It looks like black.

There will be some minor updates to the PCB version. Without further notice.

The horn will be welded before delivery. Because the wire solder joint is easy to fall off, if it falls off during transportation or installation, we are not responsible. Please weld it yourself.

Product features:

1. IPS LCD screen. A small amount of shell cutting.Easy installation. No welding is required.

2. Touch to adjust brightness and change color. Short touch is to adjust backlight brightness, long touch is to change color. Only black and white, retro, green, dark yellow, bright yellow five colors can be adjusted.The original contrast knob no longer provides function.

3. The battery life is about 20 hours.

4. The resolution of LCD is 4 times that of the original, and the picture is more delicate.

Installation tutorialInstallation precautions:

do not squeeze the LCD screen. Don't wipe the LCD screen with a wet towel.

Do not wipe the LCD screen with a rough paper towel, it will leave a scratch.

After tearing off the protective film of the LCD screen, install the LCD immediately, so that the LCD screen will be perfect.

1. Connect the LCD screen as shown in the figure. First start the LCD screen and test it to determine the connection method of LCD cable.

2. Cut the shell as shown in the figure. Install the matching LCD fixed frame. Install the LCD.

3. Touch control cable must touch the shell.

4. the circled screw in the picture below. Screw in the screws gently and do not tighten them. Due to the lack of original LCD frame, tightening the screw will squeeze the LCD screen and screw through the shell.

The touch cable can be replaced by ordinary wire. Connect to where you want.