Product Parameter

·Product Name: NC charging module;

·Product model: XY-L10A;

·Control voltage: DC6-60V;

·Control current: ≤10A;

·Control accuracy: 0.1V;

·Type of output: Direct output;

·Voltage error: ±0.1V;

·Scope of application: Various battery lithium batteries;

·Size:79*42mm.

Product Highlights

1. Support Lead-acid battery and Acting Battery, voltage range:6V~60V;

2. Can display voltage,percent of battery,charging time at the same time through LCD;

3. The function is very powerful,realizes the automatic charge control, the control charge time, also may set up and uploads the corresponding parameter through the serial port.

Function description

1. Automatic Charge control function:

By setting the volt-HI:'UP' volt-LI:'dn';When the battery voltage is below the volt-LI:'dn',the relay leads,the charger begins to charge the battery;when the battery voltage is up to volt-HI:'UP',the relay is diconnected and the automatic charge is completed once;

2. Charge Time Control Function:

How to turn on the time control function?

After entering the parameter set, set the parameter op is non-zero, then turn on the time control function, op default parameter is:--:--h, the default does not turn on time control function;

After the opening Time control function (OP is non-zero), when the battery voltage is the lower volt-LI'dn', the charger began to charge the battery, the system began to clock; During the timing, the battery voltage ≥ volt-HI'UP', relay disconnect; If the OP time is up, the battery voltage is still the lower volt-LI'dn', the relay keeps the conduction, automatically closes the charge time control function, and flashes the H:ER to remind the user, the time parameter setting is unreasonable; Press any key to stop flashing;

Note: Time format: 00:59 (00 for hours, 59 for minutes) The maximum time is 99:59, which is 100 hours.

3. Serial data upload and parameter setting function:

The system supports UART data upload and parameter setting

UART:115200,8,1

Data Upload message Format:

Battery voltage + battery percent + charge time + charge status 12.0V,020%,00:10,OP

Product Manual

1. Parameter Setting:

a) Press and hold the SET key to enter the setting interface;

b) Switch the parameters you want to set by short press SET;

Choose a ranking for this item. 1 star is the worst and 5 stars is the best.

Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product.

NOTE: HTML tags are not allowed.

Copyright (c) 2026 Officematics.com.