Plug Type	AU EU UK US

Descripción
Comentarios de clientes(0)

Item specifics

Brand Name Lincoiah
Origin CN(Origin)
Certification CE
Certification FCC
Certification RoHS
is_customized Yes
Connection Desktop
Output Type DC

Product Description

AC/DC Adapter Power Supply For FANATEC Boost Kit 180 （8NM) Fanatec GT/CSL/DD PRO

FIT FOR CSL DD and DD PRO

Superb quality and exquisite workmanship

Unlock the full potential of your CSL DD and Gran Turismo DD Pro.Designed specifically for the CSL DD and Gran Turismo DD Pro, the Boost Kit 180 provides more power to the direct-drive wheel base to enable the highest performance. This provides much stronger feedback, and as a result, you’ll feel the subtle cues more clearly too.

MAXIMUM TORQUE.

By raising the standard peak torque of 5 Nm to 8 Nm, the Boost Kit 180 transforms the force feedback of the CSL DD and Gran Turismo DD Pro due to its significantly wider dynamic range.

INSTANT UPGRADE.

Simply replace the standard power supply with the Boost Kit 180, and the wheel base unlocks its full performance automatically. No other setup required.

FEATURES

✔ Larger, 180W power supply unlocks full performance of CSL DD and Gran Turismo DD Pro (standard power supply is 90W)

✔ Designed and tested specifically for the CSL DD and Gran Turismo DD Pro

✔ Improves dynamic range (from 5 Nm to 8 Nm peak torque)

COMPATIBILITY

Wheel Bases

-CSL DD

-Gran Turismo DD Pro

Note：The Boost Kit 180 is not compatible with any other Fanatec wheel bases.

SPECIAL NOTES

>The CSL DD and Gran Turismo DD Pro were designed and tested with the Boost Kit 180 in mind; its increased performance does not compromise the durability of the wheel base.
- >The wheel base electronics can detect whether a Boost Kit 180 is connected and will release the additional power automatically.
- >This product has been tested to comply with all regional electronic safety standards. Using any other PSU voids the warranty of the wheel base and can cause hardware damage.
- >Only the standard 90W power supply or the Boost Kit 180 can be used with this wheel base. The use of any other power supply will void the wheel base warranty, is potentially dangerous and can lead to serious injury or death.

If the wheelbase does not power up when the PSU shows no problems and the LEDs on it are on, check the following:

Is the power button clicked correctly?
Did you notice any visible damage to the power port on the wheelbase?
If there are no visible hardware issues, try starting the base in bootloader mode. Press and hold the power button for 10 seconds while the dock is connected to a Windows PC with our drivers installed. The firmware update will appear on the screen. Continue with the update and try powering on the base again.
If you are using a Podium DD wheelbase with a kill switch installed, check that the kill switch button is unlocked. When using the kill switch to power off the wheelbase, the button itself will remain depressed until unlocked. This can be done by turning the button clockwise as indicated by the arrow on it.

If the PSU light goes out when you connect power, check the following:

Check the power supply and cables for damage. (Make sure the PSU is not connected to the grid!
If there is no visible damage, try connecting the PSU to a different wall outlet.