8 Pack LM2596 DC-DC Adjustable Buck Converter 3.0-40V to 1.5-35V Power Supply Step Down Module

Parameters:
Input Voltage: DC 3 -40 V
Output Voltage: DC 1.5 - 35 V
Output Current: 3A(MAX) It is recommended to use under 2A (NOTE: When using high power, add a heat sink to the power supply chip)
Load adjust ratio: +/-0.5%
Voltage adjust ratio: +/-2.5%
Transferring efficiency: 92% Max(the higher output voltage, the higher efficiency)
ON/OFF frequency: 150KHz
Output ripple: 200mV
Module feature: buck and non-isolated
Rectification method: non-synchronous rectification

Fuction:
1.Built in over-temperature protection function
2.Built in current limit function
3.Built in output short-circuit protection function

How to use
1.Access the power supply ( 3 -40 V), the power indicator light, the module is working properly.
2.Adjust the blue potentiometer knob (usually clockwise rotation boost, counterclockwise rotation Step-down) and monitor the output voltage with a multimeter to reach the required voltage.
3.A customer reflects the module output voltage can not be adjusted, always equal to the input voltage. When you encounter this problem, please first counterclockwise rotation potentiometer 10 laps above, and then use the module can be normal adjustment of the voltage.

Package includes:
8X LM2596 board


Note:
This is a buck module. The input voltage must be higher than the output voltage.
The input and output interface can not be reversed.
Keep it under 2.5 A and use the heat sink when working for long hours.