7 inch Raspberry Pi 3 Touch Screen 1024*600 800*480 Capacitive Touchscreen LCD HDMI Interface TFT Display + Acrylic Holder Case

Introduction:

1. Each touchscreen is well packed in the box , and there are HDMI cable , USB cable and CD.

2. There is the use instructions,driver,images which configured the driver ( can be use directly ) in the CD,so you can use it even you are beginner for raspberry.

3. The holder case is designed for the 7 inch touchscreen especially,there is a set screws and nuts to install it in the package.

Features:

1. Resolution: 1024 x 600 or 800 x 480 

2. USB interface capacitive touch , more convenient

3. Support the backlight control ( ON/OFF switch on the back ) , saves the electricity

4. Support the Raspberry Pi ,  provide Raspbian , Ubuntu , Win 10 system image in the CD

5. General HDMI display , can be used as a computer monitor ( touch function cannot be used )

6. HDMI interface is used to display and USB interface is used for touch and power supply.

7. This 7 inch touch screen module is designed especially for Raspberry Pi 3 Model B+/B , support the portable power , convenient for DIY.

About the system image :

1. Use the images for this touchscreen in the CD directly.

2. Configure  the raspbian system :

   1). Install the raspbian system to your sd card , open the sd card on your computer .

   2). Open the config.txt file in the root directory of sd card   , add the following code at the end of the file, save it and safely eject the sd card .

Code for 800*480 7 inch toucscreen:

 max_usb_current=1
 hdmi_group=2
 hdmi_mode=1
 hdmi_mode=87
 hdmi_cvt 800 480 60 6 0 0 0

 Code for 1024*600 7 inch toucscreen:

max_usb_current=1
hdmi_group=2
hdmi_mode=1
hdmi_mode=87
hdmi_cvt 1024 600 60 6 0 0 0

3. Use for Raspberry Pi 3 Model B+ , refer to this link:

https://github.com/goodtft/LCD-show

And here is the link of Raspbian system image configured :

 https://mega.nz/#!GcY0SKJQ!3WJc0eE7OnK5hW2EKHTRVj1Ds2_c_4G5nTGgIVZTzxo

Note :

The LCD just support Raspbian , Ubuntu and Win 10 system , if you want to use the other system image your own , you need to configure the driver to your system by yourself .

If you need to use the touch function, USB line must be connected to the raspberry pi, don't need a separate power supply.