Product Highlights

1. Support Lead-acid battery and Acting Battery, voltage range:6V~60V;

2. Can display voltage,percent of battery,charging time at the same time through LCD;

3. The function is very powerful,realizes the automatic charge control, the control charge time, also may set up and uploads the corresponding parameter through the serial port.

 

Product Parameter

·Product Name: NC charging module;

·Product model: XY-L10A;

·Control voltage: DC6-60V;

·Control current: ≤10A;

·Control accuracy: 0.1V;

·Type of output: Direct output;

·Voltage error: ±0.1V;

·Scope of application: Various battery lithium batteries;

·Size:79*42mm.

Function description

1. Automatic Charge control function:

By setting the volt-HI:'UP' volt-LI:'dn';When the battery voltage is below the volt-LI:'dn',the relay leads,the charger begins to charge the battery;when the battery voltage is up to volt-HI:'UP',the relay is diconnected and the automatic charge is completed once;

2. Charge Time Control Function:

How to turn on the time control function?

After entering the parameter set, set the parameter op is non-zero, then turn on the time control function, op default parameter is:--:--h, the default does not turn on time control function;

After the opening Time control function (OP is non-zero), when the battery voltage is the lower volt-LI'dn', the charger began to charge the battery, the system began to clock; During the timing, the battery voltage ≥ volt-HI'UP', relay disconnect; If the OP time is up, the battery voltage is still the lower volt-LI'dn', the relay keeps the conduction, automatically closes the charge time control function, and flashes the H:ER to remind the user, the time parameter setting is unreasonable; Press any key to stop flashing;

Note: Time format: 00:59 (00 for hours, 59 for minutes) The maximum time is 99:59, which is 100 hours.

3. Serial data upload and parameter setting function:

The system supports UART data upload and parameter setting

UART:115200,8,1

Data Upload message Format:

Battery voltage + battery percent + charge time + charge status 12.0V,020%,00:10,OP

Parameter Setting

a) Press and hold the SET key to enter the setting interface;

b) Switch the parameters you want to set by short press SET;

c) After the selection of parameters, it can be set by the UP/DOWN key to support the short press, long press (fast increase or decrease), To set other parameters, repeat step b, c);

After all parameters are set, long press set key to exit and save

Seleccione una clasificación para este artículo. 1 estrella es las peores y 5 estrellas es el mejor.

Por favor, dinos lo que piensas y compartir sus opiniones con los demás. Asegúrese de que sus comentarios se centran en el producto.

NOTA: No se permiten etiquetas HTML.

Copyright (c) 2026 Officematics.com.