Raspberry Pi 3 Model B+ 3.5 inch Touchscreen LCD + ABS Case + 32GB SD Card + 3A Power Adapter + Heatsinks + HDMI for RPI 3B Plus

Introduction :

3.5 inch touch screen is the most popular touch screen for Raspberry Pi . Here we design a dual use ABS case for Raspberry Pi with 3.5 inch touch screen . It means you can use the case to install Raspberry Pi and 3.5 touch screen or install Raspberry Pi with cooling Fan.  We need to mention you that when you install the 3.5 inch touch screen , the can't install the cover and fan at the same time. The case has black , gray , white and transparent 4 color to choose.

Please leave a message that which Case Color ( Black / Gray / White / Transparent ) and Power Plug ( EU / US / UK / AU ) do you want in the order note , otherwise we will send them by ourselves , please understand.

The products included in the Bundle 1 to Bundle 6 are listed in following table , please choose the correct Bundle you need.

Feature :

1. Case : 

(1). Daul use : First use : install Raspberry Pi with 3.5 inch touchscreen ; Second use : install Raspberry Pi with cooling fan ( as the following picture show )

(2). Material : ABS

(3). Color : Black / Gray / White / Transparent

(4). How to install the 3.5 inch touchscreen :

a). Install the Raspberry Pi on the base board 

b). ​Please stick the pad on  the back of 3.5 inch touchscreen ( as the picture show ) , then insert the 3.5 inch touchscreen on Raspberry Pi by GPIO pin correctly ( don't be malposed ) 

c). Install the enclusure part 

2. Power Adapter :

(1). Input : 100 - 240V, 50/60Hz AC

(2). Output : 5V 3A , DC

(3). Plug : EU / US / UK / AU ( leave a message in the order for the type you want )

(4). Chariging cable : with ON/OFF switch button on it to cut off or start the power , about 1M length

3. SD Card : 32GB capacity , Class 10 standard , with USD 2.0 SD Card reader 

4. HDMI Cable : Male to Male , about 1M length

5. Heatsinks : 2 copper one + 1 aluminum one

6. 3.5 inch touchscreen :

(1). 480*320 resolution ,   Resistive touch type ( with touch pen )

​(2). The touchscreen need to use the system configured for it , otherwise you can not use it , here we provide the system image which we have configured , the link : https://drive.google.com/open?id=18KyRmdQ_Dm--P824b5qGjkXwmIZO9jW8

You can also configure by yourself , just refer to this link : https://github.com/goodtft/LCD-show

We also provide configure way for Raspbian system in the bottom of link. If you have any problem about system , please