DYS flight control F4 PRO V2 Betaflight 

* Betaflight DYS F4 PRO firmware

* STM32F405 master with higher refresh rate and more function ports

* 5V 3A BEC output

* 9V 1.2A BEC output

* 3.3V 0.3A BEC output

* Compatible all split-type escs, connect with DYS 4-in-1 esc (F20A or F30A) with flexible flat cable

* Support BF setting software to flash and debug OSD

* Integrated current sensor to monitor the power consumption etc in real time

* Use remote control to view flight control parameter through OSD

* Support SAMRT AUDIO, adjust the VTX by OSD

* Comes with heat resistance damping ball to upgrade the stability and operation

* 3-6s lipo input, integrated PDB, max withstand current 160A

* Net weight 10.5g, exclude the cable

* The refresh rate of PID and gyro up to 8K

Data:

l Whole size: L 38mmX W 38mm, hole distance 20X20mm

l Six-layer PCB board and 3OZ copper to enhance the over-current and heat dissipation

l PDB board with reverse high voltage protection circuit

- MCU: STM32F405 GRT6

- IMU: MPU-6000

- OSD: AT7456E

- FLASH:  8M memory

- Current sensor: 0-200A

- Added S5,S6 motor control signal (support 6 axis feature once firmware upgraded)

- Integrated reverse high voltage protection circuit

- Integrated circuit protection to USB port

- 3.3V LDO to power on internal circuit

- 9V BEC: 1.2A

- 5V BEC: 3A/ one-way output to avoid external interference

- When use with 4-in-1 esc, plug in the battery to supply the flight control instead of BEC.

V+ V- : For esc power cable

S1-S6For GND of the corresponding esc signal cable

BOOT:   BOOT button  ( for firmware flash)

5V:    3A output, can connect with VTX, receiver, lens etc 5V power device at the same time

9V1.5A output, can connect with wide voltage device, such as 7-24V power VTX etc.

3.3VPower supply for DSMX etc 3.3V power device

GND:   Negative

Vout:  Video output for VTX image signal cable

Vin  Video input for camera signal cable

LED:   Programmable LED signal cable output

RX1: For sbus etc receiver

PPMFor PPM receiver signal pad

USart6 txSmart Audio set the VTX function( The VTX should support to use Smart Audio function)

BAT+/BAT-: Battery voltage

Buzz-Buzz+: Wiring for buzzer 

Installation with DYS 4-in-1 esc (optional)

Connect DYS F20A or F30A with flexible flat cable, no need to solder

Note