The customer who buy this product also pay attention to these products:

3.5 inch Raspberry Pi 3 Model B+ Touchscreen 480*320 LCD Display + Touch Pen + ABS Case Box also for Raspberry Pi 3 Model B

Note : When you use the 3.5 inch screen , you can't install the cooling fan at the same time !

Introduction :

This new case is used for the people use 3.5 inch screen : When you use the touchscreen , just remove the cover board and fan; When you don't use the touchscreen , you can use the cover and fan , which become a normal case.

Please note that you can use the 3.5 inch touchscreen and fan at the same time ! ( as the picture )

The touch screen connect to Raspberry Pi by GPIO pin only , please don't use the HDMI interface when you use the touch screen.

Feature :

1. Dual use  :

​1). This case support to install 3.5 inch touchscreen , and need to remove the cover board and fan in this using way. ( You can not install the 3.5 inch screen and fan at the same time )

2). When you don't use the 3.5 inch touchscreen , it is a general case with cooling fan.

2. Full access for Raspberry Pi : 

We leave every hole for SD card , HDMI , AV , Ethernet , USB , POE , Camera , MIPI DSI ports.

3. Support cooling fan :

You can install the cooling fan on the cover board , which make the best heat dissipation and extend the using life of Raspberry Pi.  ( You can not install the 3.5 inch screen and fan at the same time )

4. Hange hole on the bottom :

We make 2 hole on the bottom so that you can hange the case on the wall or something else . This design is very convenient when using the 3.5 inch touchscreen.

5. There are Black / Gray / White / Transaperent color to chose for the case .

6. About the pad  - use to support the screen

1). Install the Raspberry Pi on the base board 

2). ​Please stick the pad on  the back of 3.5 inch touchscreen ( as the picture show ) , then insert the 3.5 inch touchscreen on Raspberry Pi by GPIO pin correctly ( don't be malposed ) 

3). Install the cover board

Note:

This touchscreen need the driver , and we provide the system image (Raspbian) by following link:

If you want to use your own system,you need to solve the problem of driver yourself,thanks.

1. for Raspberry Pi 3 :

https://mega.nz/#!vc4zjRRR!A9OMnL4tVjXUwH5Tt4T0ES2WxJyA4DGUg-gid_JHQVA

2. for Raspberry Pi 3 Modle B+ :

https://mega.nz/#!70hDAIgC!KuVPktejNZxf8lbUD4H5wlvvRqZPrgDffmYD5xuP7ps

or refer to configure it by this link :

https://github.com/goodtft/LCD-show

If you has any problem please