• 1. Solar charging, zero electricity bill, no wiring, safe and energy saving.
• 2. Intelligent light control + PIr motion human body induction, 3-5 meters sensing distance.
• 3. IP65 waterproof, dustproof and dustproof, so you don't have to worry about it will be damaged in rainy days.
• 4. They adopt 146 and 140LED patch lamp beads, which are illuminated on four sides, with high brightness and long service life.
• 5. It is sturdy and durable.It features high-power solar panels with high photoelectric conversion.

​

Dimension:L137xW137xH54mm

Sensor mode:PIR&Light sensor

Control mode:one mode.

Waterproof type:IP65

Led quantity:146pcs SMD2835 SMD leds

Color: warm white/3000-3500k or Cold white/6000-6500k

Sensor angle:90-120deg

Body material:ABS

Battery:1pcs 18650# 1500mA

Endurance time:>14hours(under a fully charged state)

Charging time:8-10hours(depend on the sunlight)

Package:1pcs lamp+1set screws+1pcs user manual

Control mode:when someone enters the sensing area the lamp will be on.whe it leaves about 18s the lamp will gose out automatically

Body color:Black

Solar Panel:5.5v 0.55w

Solar Panel:5.5v 0.55w

Body color:Black

Dimension:L124xW196xH48mm

Sensor mode:PIR&Light sensor

Control mode:tHREE modeS.

Waterproof type:IP65

Led quantity:140pcs SMD2835 SMD leds

Color: warm white/3000-3500k or Cold white/6000-6500k

Sensor angle:90-120deg

Body material:ABS

Battery:1pcs 18650# 1200mA

Endurance time:>8hours(under a fully charged state)

Charging time:6-8hours(depend on the sunlight)

Package:1pcs lamp+1set screws+1pcs user manual

Control modes: 1) light control/charging on the daytime and light on all the night. 2) it is dim light if there is no body passed.when someone passed it turned to brightner light mode until the people leave from the sensing area. 3) The light won't turn on until someone passes by. and The lamps will go out when people leave 

How to work:

1. ​Please put the light under the sunlight 6-8 hours before using it.
2. The light&PIR motion sensor will work after switch turned to "on".
3. In the daytime or where there is light, the lamp will not light up.The light & PIR motion sensor function will be activated at night or in dark area.
4. PIR sensor: when someone enters the sensing area, the light will be on. When it leaves about 18s, the light will automatically go out.
5. Avoid usage in extreme environment like these places where is easy to produce stagnant water, no light or poor light or too hot and too cold.

Tips:If not work please check these:

1. Confirm switch is on or not.
2. It is light sensor,it can not work in the daytime,it can only work on the darkness.
3. Confirm whether it is being continuously used in a long-term and no charge,recharge it timely before use again.
4. Make sure people moving within the wensing range.
5. Make sure the solar sensor light being installed within the sensing range.
6. Confirm installation direction is correct(solar panel should be facing up).
7. Confirm no objects blocking it and solar panel can receiving sunlight.